Section: Linux-PAM Manual (8)
Return to Main Contents
pam_faildelay - Change the delay on failure per-application
pam_faildelay.so [debug] [delay=microseconds]
pam_faildelay is a PAM module that can be used to set the delay on failure per-application.
is given, pam_faildelay will use the value of FAIL_DELAY from
Turns on debugging messages sent to syslog.
Set the delay on failure to N microseconds.
MODULE TYPES PROVIDED
module type is provided.
Delay was successful adjusted.
The specified delay was not valid.
The following example will set the delay on failure to 10 seconds:
auth optional pam_faildelay.so delay=10000000
pam_faildelay was written by Darren Tucker <firstname.lastname@example.org>.
- MODULE TYPES PROVIDED
- RETURN VALUES
- SEE ALSO
This document was created by
using the manual pages.
Time: 20:36:56 GMT, September 25, 2018