Section: Linux Programmer's Manual (2)
Return to Main Contents
kill - send signal to a process
int kill(pid_t pid, int sig);
Feature Test Macro Requirements for glibc (see
_POSIX_C_SOURCE >= 1 || _XOPEN_SOURCE || _POSIX_SOURCE
can be used to send any signal to any process group or process.
If pid is positive, then signal sig is sent to the
process with the ID specified by pid.
If pid equals 0, then sig is sent to every process in the
process group of the calling process.
If pid equals -1, then sig is sent to every process
for which the calling process has permission to send signals,
except for process 1 (init), but see below.
If pid is less than -1, then sig is sent to every process
in the process group whose ID is -pid.
If sig is 0, then no signal is sent, but error checking is still
this can be used to check for the existence of a process ID or
process group ID.
For a process to have permission to send a signal
it must either be privileged (under Linux: have the
capability), or the real or effective
user ID of the sending process must equal the real or
saved set-user-ID of the target process.
In the case of
it suffices when the sending and receiving
processes belong to the same session.
(Historically, the rules were different; see NOTES.)
On success (at least one signal was sent), zero is returned.
On error, -1 is returned, and
is set appropriately.
An invalid signal was specified.
The process does not have permission to send the signal
to any of the target processes.
The pid or process group does not exist.
Note that an existing process might be a zombie,
a process which already committed termination, but
has not yet been
SVr4, 4.3BSD, POSIX.1-2001.
The only signals that can be sent to process ID 1, the
process, are those for which
has explicitly installed signal handlers.
This is done to assure the
system is not brought down accidentally.
POSIX.1-2001 requires that kill(-1,sig) send sig
to all processes that the calling process may send signals to,
except possibly for some implementation-defined system processes.
Linux allows a process to signal itself, but on Linux the call
kill(-1,sig) does not signal the calling process.
POSIX.1-2001 requires that if a process sends a signal to itself,
and the sending thread does not have the signal blocked,
and no other thread
has it unblocked or is waiting for it in
at least one
unblocked signal must be delivered to the sending thread before the
Across different kernel versions, Linux has enforced different rules
for the permissions required for an unprivileged process
to send a signal to another process.
In kernels 1.0 to 1.2.2, a signal could be sent if the
effective user ID of the sender matched effective user ID of the target,
or the real user ID of the sender matched the real user ID of the target.
From kernel 1.2.3 until 1.3.77, a signal could be sent if the
effective user ID of the sender matched either the real or effective
user ID of the target.
The current rules, which conform to POSIX.1-2001, were adopted
in kernel 1.3.78.
In 2.6 kernels up to and including 2.6.7,
there was a bug that meant that when sending signals to a process group,
failed with the error
if the caller did not have permission to send the signal to any (rather
than all) of the members of the process group.
Notwithstanding this error return, the signal was still delivered
to all of the processes for which the caller had permission to signal.
This page is part of release 3.54 of the Linux
A description of the project,
and information about reporting bugs,
can be found at
- RETURN VALUE
- CONFORMING TO
- Linux notes
- SEE ALSO
This document was created by
using the manual pages.
Time: 22:26:03 GMT, January 21, 2018